SERVICE
CMP
Testing Center
CMP Group has a professional and standardized testing center with an area of about 1000 square meters, including chemical analysis laboratory, physical testing laboratory, spectral analysis laboratory, calcination laboratory, Pavement laboratory, etc. The center is equipped with more than 30 testing personnel.
List of testing instrument
Name |
Picture |
Introduction |
X-ray diffraction and fluorescence analyzer |
|
At present, the most advanced and fastest chemical analysis can complete the analysis of AI, Fe, Si, Ti, K, Na, Ca,Mg and other elements in ten minutes. |
laser particle size analyzer |
|
Analyze particle size distribution of powders |
High-frequency fusion machine |
|
The sample can be heated to 1000℃ in 15 seconds. It has the characteristics of rapid sample preparation and no need of preheating. |
Spray drying tower |
|
Drying powder products by direct contact of hot air or other gases with droplets |
muffle furnace |
|
The sample can be heated to 1300℃ by heating with silicon carbon rod,which has the characteristics of uniform furnace temperature and accurate temperature control. |
drying oven |
|
Controllable temperature 100-300℃, used for drying samples, assisting in testing porosity, water absorption, bulk density, etc. |
Sealed jaw crusher |
|
Crushing coarse particles into fine ones |
Vibration mill |
|
Sample preparation：crushing coarse particles into fine ones |
Sieve shaker |
|
Test the Particle Size of Coarser Powder |
riffle |
|
Shrinkage sampling for non-uniform granular materials |
high temperature reheat testing furnace |
|
The highest temperature can be burned to 1700℃, and the automatic control of computer program can be realized. |
High temperature bending test furnace |
|
Test flexural strength at different temperatures. It has the function of automatic test and synchronous display. |
Thermal shock resistance test furnace |
|
Test the cold and heat shock resistance of refractories. |
Expansion coefficient measuring instrument |
|
Determine the expansion rate of refractories. The highest temperature can reach 1550℃. |
Fire resistance test furnace |
|
Measure the refractory degree of refractories. The maximum temperature can reach 1800℃. |
abrasion wear test machine |
|
Test wear-resisting property of materials |
press machine |
|
Determination of compressive and flexural strength of refractories |
Electric flexure resistance machine |
|
Test flexural value of standard test block for refractories |
True density tester |
|
Test true density of powder |
Accelerated polishing machine |
|
A fast polishing device |
Point load device |
|
Test the strength of castables, etc. |
Porosity tester |
|
Test of porosity of powder |
CMP
NO.66 Taishan Road, Tanggu, Bin Hai New Area, Tianjin, China
POST CODE：300459
EMAIL：cmpchina@cmptj.com
TEL：86 22 65556880
FAX：86 22 23133085